PD CEN TS 19102:2023
Design of tensioned membrane structures

Design of tensioned membrane structures
Standard No.
PD CEN TS 19102:2023
Release Date
2024
Published By
British Standards Institution (BSI)
Lastest
PD CEN TS 19102:2023
Scope
(1) This document applies to the design of buildings and structural works, made of structural membrane material. It provides guidance for the design of tensioned membrane structures, either mechanically or pneumatically tensioned at a defined prestress level. made of steel, aluminium, wood or other structural materials), see relevant Eurocode parts. (2) This document is concerned with the requirements for resistance, serviceability and durability of tensioned membrane structures, as given in EN 1990. structures. (3) Design and verification in this document is based on limit state design in conjunction with the partial factor method. and the combined effect of wind and rain or snow. (4) This document covers analysis methodologies appropriate for tensioned membrane structures, from analytical to full numerical simulation methods. (5) This document considers connections between membrane materials and between membrane materials and others. (6) This document is applicable for hybrid membrane structures integrating different kinds of load bearing behaviour (tension, compression, bending, inflation…), in a way that the structural membrane shares loadbearing capacity with other structural elements made of different materials. (1) The assumptions of EN 1990 apply to this document. (2) This document is intended to be used in conjunction with EN 1990, the EN 1991 series, the EN 1993 series, the EN 1999 series, ENs, EADs and ETAs for construction products relevant to tensioned membrane structures.

PD CEN TS 19102:2023 Referenced Document

  • EN 1990:2023 Eurocode - Basis of structural and geotechnical design
  • EN ISO 13934-1 Textiles - Tensile properties of fabrics - Part 1: Determination of maximum force and elongation at maximum force using the strip method
  • EN ISO 1421:2016 Rubber- or plastics-coated fabrics - Determination of tensile strength and elongation at break
  • EN ISO 527-1:2019 Plastics - Determination of tensile properties - Part 1: General principles (ISO 527-1:2019)
  • EN ISO 527-3:2018 Plastics - Determination of tensile properties - Part 3: Test conditions for films and sheets

PD CEN TS 19102:2023 history




Copyright ©2024 All Rights Reserved